Wisdom Teeth Removal

Removing wisdom teeth is almost always necessary once they start causing pain.

The cost to remove your wisdom teeth varies widely depending upon:
  • the nature of the placement of the wisdom teeth
  • the scope and nature of the treatment required
  • the number of problematic wisdom teeth

Except in the most urgent cases, Dentists on Broadbeach provide a full written costing before any treatment or removal of wisdom teeth is commenced.

Costs of Wisdom Teeth Removal
Costs can range from a base of approximately $200 for one upper straightforward wisdom tooth extraction to a base of $385 for one lower straightforward lower wisdom tooth extraction.

Wisdom teeth removal costs can vary dependent on the amount of teeth we remove at one time. It is sometimes more cost effective to do several wisdom teeth extractions at the same time, although this can result in a higher than normal amount of post-operative pain.

Are your wisdom teeth causing you pain?
Don’t hesitate – it will only get worse! Contact us to get answers to your questions and discuss problems you are having with your wisdom teeth. If you need your wisdom teeth extracted, NOW is the time, not later.

A Portfolio of our Dental Work

We could tell you about how well our gold coast dentists realign and re-set teeth, perform fillings or crowns or anything else to give you that ravishing smile.

We’d rather show you – picture says a thousand words! No matter how bad your teeth are, we can improve your smile and give you back that “wow factor” that can only come from a clean, healthy looking smile. Click here to make an appointment today!

Reconstruction of Worn & Chipped Teeth

This patient presented with chipped and decayed front teeth.
We utilised Porcelain crowns on six of his upper teeth to restore them to a healthy and highly aesthetic smile.

This patient was unhappy with her misaligned and uneven looking multi-coloured teeth. We were able to place 6 Ceramic Porcelain Crowns to acheive a uniform colour, shape & length. A very good result.

Infection Control Standards & Protocol

Its our duty of care to ensure we take every step to stop any cross-infection in the surgery. We have very strict systems and procedures in place to ensure this does not occur.

One-use disposable barriers
Plastic barriers are used to cover the areas the dentist or nurse commonly touches, such as the light handle or chair control pad. These barriers are removed after every single patient. The surgery and all of the items used, like the safety glasses and material dispensers are then wiped over with a surfactant before new barriers are placed.

The items required to complete the procedure are already set up to reduce the need for the nurse to open the cupboards and draws and single use items are used where possible. If something is required from a cupboard or drawer however, the nurse will either remove their dirty gloves or use a clean pair of tweezers to retrieve any needed items.

Post Operative Sterilisation
Once the procedure is finished, the dentist removes any sharps from his working area and disposes of them into the infectious waste sharps bin. The nurse then strips the surgery down, cleans it and takes the “dirty” instruments to the sterilisation area. Here the instruments are soaked and scrubbed before being placed into the ultrasonic cleaner, filled with disinfectant and water for 10 minutes.

An ultrasonic uses high frequency sound waves to create Cavitation bubbles. These bubbles act on any contaminants which may still be left on the instruments. The instruments are then rinsed and dried thoroughly. Instruments classed as critical (instruments that penetrate soft tissue) like extraction forceps, are placed into a single use sterilisation pouch. These instruments carry a tracking number with the date and a steam indicator. This indicator is activated when the prescribed time and temperature parameters are met. This is then recorded both in the sterilising log book as well as into the patients’ treatment card. This allows us to ensure and record that these critical instruments have been properly sterilised. Each day before the autoclave is used, we run a Helix test. In order to sterilise by steam, the steam must be able to contact every surface of every object in the load. Hollow instruments or instruments in packaging, such as the sterilisation pouches, are difficult for steam to penetrate, this is why steam sterilisers are fitted with vacuum pumps. These pumps remove the air and allow the steam to penetrate the objects. The Helix test verifies the autoclaves’ vacuum is working efficiently.

Tired Looking Crowns

This patient was very unhappy with his old and tired looking crowns. He was also unhappy with the short appearance of his teeth.

Consequently we arranged for him to have a ‘crown lengthening’ procedure where a small section of gum and bone is removed to allow for more tooth height to be achieved. After 2 weeks healing we then replaced all of his old crowns to a better shape and colour.

INSERT IMAGES

Porcelain Veneers

This patient presented with ‘chalky’ looking mottled teeth from a developmental defect.

She was very self conscious about their appearance. After careful assessment and planning we made 6 porcelain veneers for her. She was extremely grateful and happy with the result we were able to achieve. It has been a life changing experience for her.

IMAGES

Dental Fissure Sealants

Dental fissure sealants (also known as fissure sealants) are defined as a preventative dental treatment, where a clear material is flowed in the pits and fissures (grooves) or chewing surfaces of permanent molar & premolar teeth at the back of the mouth.

Why do we recommend them?

Most adult molars (mainly the 6 year old and 12 year old molars) erupt with very deep grooves in the chewing surfaces. The grooves (called pits & fissures) are able to trap and harbour bacteria easily. It is very difficult to clean these areas when we brush our teeth. Most fissure sealant materials are fluoride releasing as well, which adds even more protection for the tooth surface.

Are the invasive? Do they hurt?

Fissure sealants are a very conservative minimally invasive treatment. We do not drill away any tooth. We do not need to give local anaesthetic. We use a special etch to wash the teeth and grooves and then flow a clear resin varnish over the grooves to protect them from bacteria and furthermore decay. This resin material is set hard with our high intensity blue light and the patient is able to eat on them and carry on as normal straight away.

When should they be done?

Fissure sealants are best done when the tooth is newly erupted (usually when children are age 6 & 7 and then again at age 12 & 13) when we know that there is little bacteria in the grooves already. Doing them at a later stage after the tooth has erupted for some time is unfavourable. we can risk trapping bacteria in the grooves under the seal and this can cause decay to form.

Gaps, Worn or Chipped Teeth

This patient presented with large gaps and worn down and chipped teeth. We placed 6 composite resin veneers and the patient was elated at what we had acheived for an affordable cost <$3000 ! Less than half of what porcelain veneers would cost. This was also able to be done in 1 visit ! Any chips or repairs needed in the future are quick and easy.

INSERT BEFORE AFTER IMAGES